The Anderic UC9051T wireless wall controller and UC7067GMRX receiver kit converts a pull-string 3-speed or 4-speed ceiling fan to wall control.
Specifications
- Kit: Anderic UC9051T-UC7067GMRX
- Radio frequency (RF): 303.875 MHz
- Battery: 1 A23 (not included)
Good to Know
- Reverse works only on fans built with reverse.
- Follow the installation instructions included with the kit; for wiring questions, use a licensed electrician.
Setup / Pairing
Installing the UC7067GMRX receiver
WARNING: High voltage. Household electrical power can cause serious injury or death. Disconnect power to the ceiling fan by removing the fuse or switching off the circuit breaker.
- Remove the ceiling fan canopy from the mounting bracket.
- Disconnect the existing wiring between the ceiling fan and the supply at the junction box. If you are replacing a receiver, disconnect all of its wires.
- Lay the black antenna wire on top of the receiver and put the receiver in the mounting bracket.
- Make these connections with the supplied wire nuts: black receiver wire (AC IN L) to black supply wire; white receiver wire (AC IN N) to white supply wire; white receiver wire (TO MOTOR N) to white fan wire; black receiver wire (TO MOTOR L) to black fan wire; blue receiver wire (FOR DOWN LIGHT) to blue fan wire; red receiver wire (FOR UPPER LIGHT) to red fan wire.
- Push all connected wires up into the junction box.
- Reinstall the canopy on the mounting bracket.
- Restore the electrical power.
Setting the codes
- Before reinstalling the fan housing or canopy, note the dip switch pattern on the UC7067GMRX receiver (or set it to the pattern you want).
- On the remote, remove the battery cover and slide the 4 dip switches up or down. The factory setting is all switches up; we recommend using a different combination.
- Set the switches on the remote to EXACTLY match the switches on the UC7067GMRX receiver. The remote and receiver will only work together when both patterns are the same.
- Replace the battery cover, restore power and test the fan and light.
What's in the Box
- 1 remote and 1 receiver
- Battery not included
Compatible Models
- Other part numbers: UC9051T-UC7067GMRX
- 3-speed or 4-speed pull-string ceiling fans, or fans with a canopy-style receiver
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
FCC ID : CHQ8BT9051T
Frequency (MHz) : 303.875