The Anderic RR7216T (FCC ID CHQ7216T) is a ceiling fan remote for 3-speed fans with a UC7067FMRX or FAN28R receiver.
How to confirm the fit
Find the FCC ID on the back of your old remote or inside its battery compartment. It should match CHQ7216T. Match your complete original remote or receiver model against the verified compatibility list and pairing hardware. Listed FCC IDs are examples or identifiers, not a requirement that every compatible original share one FCC.
Specifications
- Shipped remote: Anderic RR7216T
- FCC ID: CHQ7216T
- Radio frequency (RF): 303.925 MHz
- Batteries: 2 AAA (not included)
Good to Know
- It pairs by matching dip switches with the receiver.
- Key names, layout and the look of the case may differ from the original. Compare your original's buttons before ordering.
Setup / Pairing
Turn off power at the circuit breaker before opening the canopy or touching or adjusting the receiver. Match or record receiver switches with power off; close covers, then restore power to test. If you are not opening the receiver, you may try remote-only code patterns.
Before you start
- This remote pairs by matching its 4 dip switches to the receiver in your fan (16 code combinations).
- Set the dip switches before inserting the battery; you cannot reach the dip switch panel while the battery is in the compartment.
- Batteries are not included.
Pairing by matching the dip switches (4-switch, 16 codes)
- Make sure the fan has power and works correctly.
- Push firmly below the arrow and slide the battery cover off the remote.
- Set the remote's 4 dip switches to EXACTLY the same up/down pattern as the switches on the fan's receiver. Use a small screwdriver or the tip of a ballpoint pen. The factory default is all switches up.
- Replace the battery cover and test the remote.
Pairing without reaching the receiver
- Set the remote's dip switches to the first code pattern in the code chart (included with the remote).
- Press any button to test whether the fan responds.
- If it does not, move to the next dip switch pattern and test again. Repeat until the fan responds; there are 16 patterns.
What's in the Box
- 1 Anderic RR7216T remote
- Wall mount bracket
- Batteries not included
Compatible Models
- Hampton Bay UC7216T / CHQ7216T (UC7067FMRX or FAN28R receivers)
- Other part numbers: 4-DIP
- Also works with: Mercer 52 in Integrated LED Indoor Matte Black, Mercer 52 in Integrated LED Indoor OilRubbed Bronze, Mercer 52 in Integrated LED Indoor White, Mercer 52 in LED Brushed Nickel, Mercer 52 in LED Indoor Distressed Koa, Mercer 56 in Integrated LED Brushed Nickel, Mercer 56 in Integrated LED Indoor Oil Rubbed Bronze, Mercer 56 in Integrated LED Indoor White
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
Battery Required : AA Battery 2 pack
Frequency Type : RF/Bluetooth
FCC ID : CHQ7216T
Frequency (MHz) : 303.925
Dimensions: 2.00 x 6.00 x 1.00 (W x L x D, inches)