The Anderic WindwardIIIKit is a substitute for the Hampton Bay UC7085T. It is a ceiling fan remote and receiver kit (RR7080T remote and UC7067GMRX receiver).
Specifications
- Kit: Anderic WINDWARDIIIKIT
- Radio frequency (RF): 303.8 MHz
- Battery: 1 9-Volt (not included)
Good to Know
- It comes with its own receiver and remote; the existing receiver and remote are not used.
- For 3-speed AC ceiling fans; the UC7067GMRX receiver is wired into the fan canopy.
- Key names, layout and the look of the case may differ from the original. Compare your original's buttons before ordering.
Setup / Pairing
- Turn off power at the circuit breaker or fuse box.
- Remove the fan canopy and disconnect the existing wiring between the fan and the house supply, including any old receiver.
- Connect the receiver with the supplied wire nuts: receiver black (AC IN L) to the house black wire, receiver white (AC IN N) to the house white wire, receiver white (TO MOTOR N) to the fan white wire, receiver black (TO MOTOR L) to the fan black wire, receiver blue (FOR DOWN LIGHT) to the fan blue down-light wire, and receiver red (FOR UPPER LIGHT) to the fan red up-light wire; connect the fan green wire to the bare house ground.
- Lay the antenna wire on top of the receiver, place the receiver in the mounting bracket, push the wires into the box and reinstall the canopy.
- With power still off, set the RR7080T and receiver code switches to identical positions.
- Insert a 9V battery (not included), reassemble, restore power and test. There is no LEARN-button procedure.
What's in the Box
- 1 remote and 1 receiver
- Battery not included
Compatible Models
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
Battery Required : 23a 12V
Frequency Type : RF/Bluetooth
FCC ID : CHQ7085T
Frequency (MHz) : 303.8
Dimensions: 2.00 x 6.00 x 1.00 (W x L x D, inches)