The Anderic RR7096TR is a thermostatic ceiling fan remote control with a reverse key, for the CHQ7096T / CHQ8BT7096T remote system.
How to confirm the fit
Find the FCC ID on the back of your old remote or inside its battery compartment. It should match CHQ7096T. Match your complete original remote or receiver model against the verified compatibility list and pairing hardware. Listed FCC IDs are examples or identifiers, not a requirement that every compatible original share one FCC.
Specifications
- Shipped remote: Anderic RR7096TR
- FCC ID: CHQ7096T
- Radio frequency (RF): 302.739 MHz
- Batteries: 4 AAA (not included)
Good to Know
- If your old remote CHQ8BT7096T Hampton Bay remote has a red light button, this remote will not work the lights.
- It must use the same frequency as your old remote. Check the FCC ID on your old remote before ordering.
Setup / Pairing
Turn off power at the circuit breaker before opening the canopy or touching or adjusting the receiver. Match or record receiver switches with power off; close covers, then restore power to test. If you are not opening the receiver, you may try remote-only code patterns.
Before you start
- This remote pairs by matching its 4 dip switches to the receiver in your fan (16 code combinations).
- Set the dip switches before inserting the battery; you cannot reach the dip switch panel while the battery is in the compartment.
- Batteries are not included.
Pairing by matching the dip switches (4-switch, 16 codes)
- Make sure the fan has power and works correctly.
- Push firmly below the arrow and slide the battery cover off the remote.
- Set the remote's 4 dip switches to EXACTLY the same up/down pattern as the switches on the fan's receiver. Use a small screwdriver or the tip of a ballpoint pen. The factory default is all switches up.
- Replace the battery cover and test the remote.
Pairing without reaching the receiver
- Set the remote's dip switches to the first code pattern in the code chart (included with the remote).
- Press any button to test whether the fan responds.
- If it does not, move to the next dip switch pattern and test again. Repeat until the fan responds; there are 16 patterns.
What's in the Box
- 1 Anderic RR7096TR remote
- Wall mount bracket
- Batteries not included
Compatible Models
- ceiling fans that use the CHQ8BT7096T remote
- Works with many Hampton Bay ceiling fans, including models such as 54WWD, 7658GM01, 54CVT and TRC100L.
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to the full compatible models list.
Battery Required : AAA Batteries 4 Pack
Frequency Type : RF/Bluetooth
FCC ID : CHQ7096T
Frequency (MHz) : 302.739
Dimensions: 2.00 x 6.00 x 1.00 (W x L x D, inches)