The Anderic RR7080T is a 304 MHz ceiling fan remote with up-light and reverse keys that pairs by matching dip switches.
How to confirm the fit
Find the FCC ID on the back of your old remote or inside its battery compartment. It should match CHQ7080T1 or CHQ7078T. Match your complete original remote or receiver model against the verified compatibility list and pairing hardware. Listed FCC IDs are examples or identifiers, not a requirement that every compatible original share one FCC.
Specifications
- Shipped remote: Anderic RR7080T
- FCC ID: CHQ7080T1 / CHQ7078T
- Radio frequency (RF): 303.875 MHz
- Battery: 1 9-Volt (not included)
Good to Know
- For 3-speed fans that have a UC7067GMRX-type receiver installed
- The reverse key works only if the fan has a reversing module or a receiver with reverse built in
- 304 MHz only
Setup / Pairing
Turn off power at the circuit breaker before opening the canopy or touching or adjusting the receiver. Match or record receiver switches with power off; close covers, then restore power to test. If you are not opening the receiver, you may try remote-only code patterns.
- Make sure the fan has power and works with its wall switch on.
- Remove the remote's battery cover: push firmly below the arrow and slide it off. Set the code switches before installing the battery, because on some models the battery covers the switch panel.
- With a small screwdriver or pen tip, slide the 4 code (dip) switches up or down to a pattern of your choice. The factory setting is all up.
- Set the 4 code switches on the fan's receiver to exactly the same pattern as the remote. The remote and receiver only work together when the patterns match.
- Insert the battery (not included), matching the polarity marks, and replace the battery cover.
- Test: press a fan speed key and the light key. The fan and light respond when the patterns match.
- If you cannot reach the receiver: set the remote's switches to one of the 16 patterns, press a key to test, and if the fan does not respond, move to the next pattern. Repeat until the fan responds.
- If the fan or light turns on and off by itself, another remote is interfering: set a new matching pattern on both the remote and the receiver.
What's in the Box
- 1 Anderic RR7080T remote
- Wall mount bracket
- Battery not included
Compatible Models
- Works with many Hampton Bay ceiling fans, including models such as AC374 and AC374WB.
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to the full compatible models list.
FCC ID : CHQ7080T1
Frequency (MHz) : 303.875
Dimensions: 2.00 x 6.00 x 1.00 (W x L x D, inches)