The Anderic RR7099TKIT is a substitute kit for the Harbor Breeze RC104L remote. It is a ceiling fan remote and receiver kit with a wall mount.
Specifications
- Shipped kit: Anderic RR7099TKIT
- Radio frequency (RF)
- Battery: 1 9-Volt (not included)
Good to Know
- Does not work with fans that use the KUJCE9201 system
- The receiver must be installed in the fan
- Key names and layout may differ from the original. Compare your original's buttons before ordering.
- This is a kit that includes a receiver; the Harbor Breeze RC104L is a remote only.
Setup / Pairing
The RR7099T remote alone does not operate the original KUJCE9201 receiver. Install the supplied UC7067FCRX receiver and use the matched remote that comes with this kit.
With the breaker OFF, install the receiver and set or record its code switches; set the remote to the identical pattern, close all covers and the canopy, then restore power and test. Remote-only code trials may be done without opening an energized receiver.
- Turn the power to the fan off at the circuit breaker. Install the receiver in the fan canopy following the wiring instructions included with the kit, then restore power.
- Remove the remote's battery cover: push firmly below the arrow and slide it off. Set the code switches before installing the battery, because on some models the battery covers the switch panel.
- With a small screwdriver or pen tip, slide the 4 code (dip) switches up or down to a pattern of your choice. The factory setting is all up.
- Set the 4 code switches on the fan's receiver to exactly the same pattern as the remote. The remote and receiver only work together when the patterns match.
- Insert the battery (not included), matching the polarity marks, and replace the battery cover.
- Test: press a fan speed key and the light key. The fan and light respond when the patterns match.
- If you cannot reach the receiver: set the remote's switches to one of the 16 patterns, press a key to test, and if the fan does not respond, move to the next pattern. Repeat until the fan responds.
- If the fan or light turns on and off by itself, another remote is interfering: set a new matching pattern on both the remote and the receiver.
What's in the Box
- 1 Anderic RR7099T remote and 1 UC7067FCRX receiver
- Wall mount bracket
- Battery not included
Compatible Models
- Harbor Breeze RC104L
- Supplied with: 0276094 Harbor Breeze Aero Ceiling Fan, EAER52BRZ5LKRCI Harbor Breeze Aero Ceiling Fan
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
Dimensions: 2.00 x 6.00 x 1.00 (W x L x D, inches)