This MR77A ceiling fan remote control kit replaces the receiver and remote on Altura 56 in. and 68 in. ceiling fans that used the MR77A system.
Specifications
- Radio frequency (RF)
- Battery: 1 A23 (not included)
- Includes a replacement MR77A-compatible receiver, matching remote and instructions
Good to Know
- Replaces both the receiver and the remote.
- Only for Altura fans that used the MR77A system.
- Follow the installation instructions included with the kit; for wiring questions, use a licensed electrician.
Setup / Pairing
Complete all receiver DIP, wiring, and canopy work with the circuit breaker off; reassemble, then restore power to test. If you later need to access the receiver again, isolate power at the breaker first.
Turn off power at the circuit breaker before opening the canopy or touching or adjusting the receiver. Match or record receiver switches with power off; close covers, then restore power to test. If you are not opening the receiver, you may try remote-only code patterns.
Step 1: Install the MR77A receiver
- A qualified electrician is recommended. Disconnect the fan from power at the wall switch before you begin.
- Disassemble the fan housing to expose the old receiver (see the fan's instructions).
- Unscrew and unplug the old receiver, keeping the screws.
- Plug in the new receiver; make sure the 9-pin square plug is aligned and clicks into place. If you have a light kit, also connect the blue and white light wires (if the plugs do not align, cut them off and join the wires with wire nuts).
- Secure the receiver with the existing screws in the same location, and reinstall the housing.
Step 2: Pair the remote
- Remove the remote's battery cover (press firmly on the arrow and slide it off) and install the A23 battery (not included).
- Slide the four code switches to your choice of up or down. Avoid the default position, and use a different pattern for each fan.
- Turn the fan power off at the circuit breaker or wall switch, then restore it.
- Within 30 seconds, press and hold POWER (FAN OFF) for up to 10 seconds. The receiver learns the remote's pattern, and the downlight (if any) blinks twice.
The remote and receiver must be on the same frequency: CHQ7222T remotes (304 MHz) work with MR7703, UC7301R, UC7301R-01, UC7301R-03 and UC7305R receivers; CHQ7222T434, TR171B and KUJCE10205 remotes work with MR77A and MR77A.2 receivers.
What's in the Box
- 1 remote and 1 receiver
- Battery not included
Compatible Models
- Supplied with: Altura 56 INCH Indoor Brushed Nickel, Altura 56 INCH Indoor Gilded Espresso, Altura 56 INCH Oil Rubbed Bronze, Altura 68 inch, Altura 68 Inch Oil Rubbed Bronze
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
Battery Required : 23a 12V
Dimensions: 5.00 x 5.00 x 2.00 (W x L x D, inches)