The Anderic MR77A-RR7222T434-KIT is a substitute kit for the KUJCE9811. It is a 434 MHz ceiling fan remote and receiver set for MR77A-type fans.

Specifications

• Kit: Anderic MR77A-RR7222T434-KIT
• Radio frequency (RF): 433.9 MHz
• Battery: 1 A23 (not included)
• Includes the RRMR77A receiver, the RR7222T434 remote and a wall mount

Good to Know

• It comes with its own receiver; your existing remote does not pair with it.
• It is 434 MHz only: it does not work with 304 MHz CHQ7222T-family parts.
• Key names and layout may differ from the original. Compare your original's buttons before ordering.

Setup / Pairing

1. Turn off power to the fan at the wall switch or circuit breaker. A qualified electrician is recommended for installing the receiver.
2. Open the fan housing, unscrew and unplug the old receiver, and keep the screws.
3. Plug in the new receiver and make sure the 9-pin square plug clicks into place. If you have a light kit, also connect the blue and white light wires.
4. Secure the new receiver in the same place with the existing screws, then reinstall the fan housing.
5. On the remote, press firmly on the arrow and slide the battery cover off. Insert an A23 (12V) battery, matching the polarity marks.
6. Slide the four code switches to a pattern of your choice. Avoid the default position, and use a different pattern for each fan.
7. Turn the fan power off at the circuit breaker or wall switch, then restore it.
8. Within 30 seconds, press and hold POWER (FAN OFF) for up to 10 seconds. The fan's downlight blinks twice when it pairs; a fan without a light gives no signal.
9. To dim the light, set the DIM switch inside the battery compartment to ON, then press and hold LIGHT.

What's in the Box

• 1 remote and 1 receiver
• Wall mount bracket
• Battery not included

Compatible Models

• Listed for the KUJCE9811. Works with MR77A-type fans

Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.