The Anderic RR7099TKIT is a substitute kit for the Harbor Breeze KUJCE9201: an RR7099T remote, a UC7067FCRX receiver and a wall mount.
Specifications
- Kit: Anderic RR7099TKIT
- Radio frequency (RF)
- Battery: 1 9-Volt (not included)
- Fan speed (Low, Medium, High) and light with dimming 20 to 100 percent
Good to Know
- The RR7099T remote does not work with the KUJCE9201 receiver in your fan. The included UC7067FCRX receiver must be installed in its place.
- It has no reverse key.
- It pairs by dip switches.
Setup / Pairing
With the breaker OFF, install the receiver and set or record its code switches; set the remote to the identical pattern, close all covers and the canopy, then restore power and test. Remote-only code trials may be done without opening an energized receiver.
- Turn the power to the fan off at the circuit breaker. Install the receiver in the fan canopy following the wiring instructions included with the kit, then restore power.
- Remove the remote's battery cover: push firmly below the arrow and slide it off. Set the code switches before installing the battery, because on some models the battery covers the switch panel.
- With a small screwdriver or pen tip, slide the 4 code (dip) switches up or down to a pattern of your choice. The factory setting is all up.
- Set the 4 code switches on the fan's receiver to exactly the same pattern as the remote. The remote and receiver only work together when the patterns match.
- Insert the battery (not included), matching the polarity marks, and replace the battery cover.
- Test: press a fan speed key and the light key. The fan and light respond when the patterns match.
- If you cannot reach the receiver: set the remote's switches to one of the 16 patterns, press a key to test, and if the fan does not respond, move to the next pattern. Repeat until the fan responds.
- If the fan or light turns on and off by itself, another remote is interfering: set a new matching pattern on both the remote and the receiver.
What's in the Box
- 1 remote and 1 receiver
- Battery not included
Compatible Models
- Listed for the Harbor Breeze KUJCE9201. The included receiver replaces the KUJCE9201 receiver
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
Battery Required : 9 Volt Battery
Frequency Type : RF/Bluetooth
FCC ID : KUJCE9201
Frequency (MHz) : 304.0
Dimensions: 2.00 x 6.00 x 1.00 (W x L x D, inches)