The Anderic FAN2R-RR7078TR-KIT is a substitute for the Hunter CP9110R/IN2RX01/UC7848R receiver. It is a Hunter-style FAN2R receiver with RR7078TR remote kit that pairs by matching 4 code (dip) switches on 304 MHz.
Fit note: If your original receiver is the round version about 3.25 inches in diameter, this substitute will not fit inside that housing.
Specifications
- Kit: Anderic FAN2R-RR7078TR-KIT
- Radio frequency (RF): 304 MHz
- Battery: 1 9-Volt (not included)
Good to Know
- Fit note: Some Hunter receivers are a round version about 3.25 inches in diameter. If your original receiver is the 3.25-inch round version, this substitute will not fit inside that housing. Check your receiver's size before ordering.
- 304 MHz only; requires receiver install
- If your fan has an AMP-type plug instead of the 9-pin square (Molex) plug, an adapter cable is needed.
- Key names and layout may differ from the original. Compare your original's buttons before ordering.
Setup / Pairing
- Turn off power to the fan at the circuit breaker. A qualified electrician is recommended for installing the receiver.
- Open the fan housing (see your fan's instructions) and unplug the old receiver. If the old receiver used tabs or clips, they can be broken off so the new receiver fits.
- Plug the fan's 9-pin square plug into the new receiver until it clicks into place. If you have a light kit, also connect the blue and white light wires, matching colors.
- Note the receiver's 4 code (dip) switch pattern, or set the pattern you want (the factory setting is all up; a different pattern is recommended), then reinstall the fan housing.
- On the remote, press firmly below the arrow and slide the battery cover off. Set the remote's 4 code switches to exactly match the receiver before inserting the battery.
- Insert a 9-Volt battery (not included), matching the polarity marks, and replace the battery cover.
- Restore power and test the fan speeds, the light and the Reverse key. To dim the light, press and hold the light key.
- If the fan or light turns on and off by itself, another remote is interfering: set a new matching pattern on both the remote and the receiver.
What's in the Box
- 1 remote and 1 receiver
- Battery not included
Compatible Models
- Hunter CP9110R/IN2RX01/UC7848R
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
Dimensions: 4.00 x 4.00 x 3.00 (W x L x D, inches)