The Anderic FAN2R-RR7078TR-KIT is a ceiling fan remote and receiver kit for 3-speed fans: an RR7078TR remote and a reversing receiver that pair by matching 4 dip switches on 304 MHz.
Specifications
- Kit: Anderic FAN2R-RR7078TR-KIT
- Radio frequency (RF): 304 MHz
- Battery: 1 9-volt (not included)
Good to Know
- If your fan has an AMP-type plug instead of the 9-pin square (Molex) plug, an adapter cable is needed.
Setup / Pairing
- Turn off power to the fan at the circuit breaker. A qualified electrician is recommended.
- Open the fan housing (see your fan's instructions) and unplug the old receiver.
- Fit the new receiver; if the old receiver used tabs or clips, they can be broken off so the new one fits.
- Plug the fan's square 9-pin plug into the receiver, then connect the blue and white light-kit wires, matching colors.
- Note the receiver's 4 dip-switch pattern (or set the pattern you want) and reinstall the housing.
- Remove the remote's battery cover and set its 4 dip switches to exactly match the receiver before inserting the battery (factory setting is all up; a different pattern is recommended).
- Insert the 9-volt battery (not included), matching the polarity marks, and replace the cover.
- Restore power and test the fan speeds, light and Reverse key.
- If the fan or light turns on and off by itself, another remote is interfering: set a new matching pattern on both the remote and the receiver.
Safety: turn off power at the circuit breaker before opening the fan canopy or touching the receiver.
What's in the Box
- 1 remote and 1 receiver
- Battery not included
Compatible Models
- Works with many Hunter ceiling fans, including models such as 8511202, 85069-060 and 23530420.
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to the full compatible models list.
Frequency (MHz) : 304.0
