The Anderic DC8-96SG8 is a DC ceiling fan receiver that pairs with the DC1 remote.
Specifications
- Shipped receiver: Anderic DC8-96SG8
- Radio frequency (RF): 315 MHz
- Operating range: approximately 10 meters
- Receiver for DC ceiling fans: 6 fan speeds, fan off, forward/reverse and light on/off with dimming
- Up to 40 W motor output and 60 W LED light output, 120 VAC 60 Hz
Good to Know
- This is a receiver only. No remote is included; it works with the DC1 remote, sold separately.
- It is for DC motor ceiling fans only, within 40 W motor and 60 W LED light output. It does not work on AC fans.
- Do not use a wall dimmer switch to control the fan speed.
- Before ordering, match your fan's receiver label and wiring to the DC8 type.
Setup / Pairing
- Turn the power off at the circuit breaker. Install the DC8 receiver in the fan following the fan's wiring instructions, then restore power.
- Remove the remote's battery cover, insert 2 AAA batteries (not included) and replace the cover.
- Choose the light setting: DIM lets the light dim and brighten while you hold the light key; ON gives light on/off only. The remote is set to DIM at the factory.
- Universal mode: set the remote's dip (code) switch to the upper COMMON CODE position. The remote is ready to use. Other remotes in the same setting can also control the fan.
- Learning mode (to pair one specific remote): set the dip switch to the lower L.CODE position. Turn the fan power off at the circuit breaker for at least 10 seconds, then turn it back on.
- Within 60 seconds of restoring power, press and hold the LEARN button for at least 3 seconds.
- If the fan has a light, it blinks twice when pairing is complete. For a fan without a light, test with the remote.
- If it does not pair, make sure the power was off for at least 10 seconds and repeat. A fan can be controlled by up to two remotes; to control several fans together, set their dip switches the same.
Troubleshooting
- After turning the power on, do not press any other button before the learn key, or pairing will fail.
- If the fan does not respond, turn the power to the receiver off and repeat the pairing.
- Each remote runs one fan; fans on the same breaker must be wired and paired one at a time.
What's in the Box
- 1 Anderic DC8-96SG8 receiver
Compatible Models
- Anderic DC8-96SG8
- Works with many Kendal ceiling fans, including models such as AC22054BLK and AC22054SN.
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to the full compatible models list.
Key Features
• Model-Specific Compatibility: Designed exclusively for fans equipped with the DC8-96SG8 receiver, ensuring a precise fit and seamless integration.
• Enhanced Speed Control: Enjoy 6-speed functionality along with reverse settings for customized comfort.
• Dual Power Output: Provides a maximum output of 40W for the motor and 60W for the light (LED), delivering efficient and adjustable performance.
• Anderic DC1 Remote Compatibility: Works seamlessly with the Anderic DC1 remote control, offering a comprehensive fan control solution.
• Wide Fan Compatibility: Compatible with 6-speed fans initially pre-installed with the same model receiver, catering to various fan models for added versatility.
Dimensions: 4.00 x 4.00 x 3.00 (W x L x D, inches)