The Anderic DC1/DC8 Ceiling Fan Kit pairs the Anderic DC8-96SG8 DC ceiling fan receiver with the Anderic DC1 remote, for Monte Carlo, Casa Vieja, Hampton Bay and Home Decorators Collection DC fans.
Specifications
- Kit: Anderic DC1/DC8
- Radio frequency (RF)
- Batteries: 2 AAA (not included)
- Operating range: approximately 10 meters
- DC8 receiver for DC ceiling fans: up to 40 W motor output and 60 W LED light output, 120 VAC 60 Hz
Good to Know
- It comes with its own receiver and remote; the existing receiver and remote are not used.
- The receiver is wired into the fan; switch off the power at the circuit breaker before installing it.
- Do not use a wall dimmer switch to control the fan speed.
- Key names, layout and the look of the case differ from the original. Compare your original's buttons before ordering.
Setup / Pairing
- Choose the mode with the dip (code) switch in the remote. Universal mode: set it to the upper COMMON CODE position; the remote is ready to use, and other remotes in the same setting can also control the fan.
- Learning mode (to pair one specific remote): set the switch to the lower L.CODE position. Turn the fan power off at the circuit breaker for at least 10 seconds, then turn it back on.
- Within 60 seconds of restoring power, press and hold LEARN for at least 3 seconds.
- If the fan has a light, it blinks twice when pairing is complete. For a fan without a light, test with the remote.
- If it does not pair, make sure the power was off for at least 10 seconds and repeat. A fan can be controlled by up to two remotes; to control several fans together, set their dip switches the same.
Troubleshooting
- After turning the power on, do not press any other button before the learn key, or pairing will fail.
- If the fan does not respond, turn the power to the receiver off and repeat the pairing.
- Each remote runs one fan; fans on the same breaker must be wired and paired one at a time.
What's in the Box
- 1 remote and 1 receiver
- Wall mount bracket
- Batteries not included
Compatible Models
- Works with many Kendal ceiling fans, including models such as AC22054BLK and AC22054SN.
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to the full compatible models list.
FCC ID : 2AAZPDC1
Frequency (MHz) : 315.0
