The Anderic CHQ9051T is a substitute for the Fanimation C23 / UC-9051T remote. It is a wireless wall-mount ceiling fan control.
How to confirm the fit
Find the FCC ID on the back of your old remote or inside its battery compartment. It should match CHQ9051T. Match your complete original remote or receiver model against the verified compatibility list and pairing hardware. Listed FCC IDs are examples or identifiers, not a requirement that every compatible original share one FCC.
Specifications
- Shipped remote: Anderic CHQ9051T
- FCC ID: CHQ9051T
- Radio frequency (RF): 303.875 MHz
- Battery: 1 A23 (not included)
Good to Know
- Dip switches must match the receiver
- Key names and layout may differ from the original. Compare your original's buttons before ordering.
Setup / Pairing
Turn off power at the circuit breaker before opening the canopy or touching or adjusting the receiver. Match or record receiver switches with power off; close covers, then restore power to test. If you are not opening the receiver, you may try remote-only code patterns.
- Remove the faceplate: use the notch at the bottom of the wall control to unsnap it.
- Insert an A23 battery (not included) into the battery compartment, matching the polarity marks.
- Set the 4 dip switches to exactly the same pattern as the dip switches on the receiver in your fan. If you do not know the receiver's pattern, step through the 16 patterns in the 4-dip switch chart, testing a key after each change, until the fan responds.
- Snap the faceplate back on and test the fan speeds, light and reverse keys. If the fan does not respond, recheck that the patterns match.
What's in the Box
- 1 Anderic CHQ9051T remote
- Battery not included
Compatible Models
- Fanimation C23 / UC-9051T
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
FCC ID : CHQ9051T
Frequency (MHz) : 303.875
