This generic remote is for Genie Intellicode openers that use 390 MHz (1995 to current), like the ACSCTG Type 3 / GIT-3.

Specifications

• Radio frequency (RF): 390 MHz
• Battery: 1 CR2025 (not included)

Good to Know

• Genie Intellicode 390 MHz openers only.
• It is a generic substitute, not a Genie-made remote.

Setup / Pairing

Step 1: Put the opener into programming mode

• Newer Genie openers: press and hold the program button until the round LED turns blue, then release. The small round LED goes out and the long LED flashes purple.
• Genie openers and add-on receivers made from 1995 to 2011: press and release the Learn Code button once. The red LED begins to flash.

Step 2: Program the remote (within about 30 seconds)

1. Pull the protective battery tab from the remote, if present.
2. Stand at least 5 feet from the opener.
3. Slowly press and release the remote button of your choice two times. The opener LEDs flash and go off to confirm.
4. Press the same button a third time; the door opens or closes. If the LEDs do not go off, press the button a few more times.

Erasing all remotes (lost or stolen remote)

• Newer Genie openers: press and hold the program button until the round LED turns blue, release, then press and hold Up (+) and Down (-) together until both LEDs turn solid blue.

What's in the Box

• 1 generic replacement remote
• Visor clip
• Battery not included

Compatible Models

• Genie Intellicode 390 MHz openers, 1995 to current (ACSCTG Type 3, GIT-3)

Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.