The Anderic AND-RR7080T-UC7058GM-KIT is a substitute for the Hampton Bay 7058RLCK-03 Green receiver, supplied as a kit: a UC7058 receiver and an RR7080T remote on 304 MHz. It is not an exact copy of your old remote.
What it can do
- Receiver with fan reverse and separate up and down light control
- RR7080T remote: fan speeds (LO, MED, HI, OFF), light with dimming, up-light key and reverse key
- Remote uses 1 9-Volt battery, which is not included
How it differs
- It comes with its own receiver and remote; your existing remote does not pair with the new receiver.
- It does not add features your fan did not already have; the up-light and reverse keys work only on fans built with an upper light and reverse.
- It works on 304 MHz only and pairs by dip switches.
Setup / Pairing
- Turn the power to the fan off at the circuit breaker. Install the receiver in the fan canopy following the wiring instructions included with the kit, then restore power.
- Remove the remote's battery cover: push firmly below the arrow and slide it off. Set the code switches before installing the battery, because on some models the battery covers the switch panel.
- With a small screwdriver or pen tip, slide the 4 code (dip) switches up or down to a pattern of your choice. The factory setting is all up.
- Set the 4 code switches on the fan's receiver to exactly the same pattern as the remote. The remote and receiver only work together when the patterns match.
- Insert the battery (not included), matching the polarity marks, and replace the battery cover.
- Test: press a fan speed key and the light key. The fan and light respond when the patterns match.
- If you cannot reach the receiver: set the remote's switches to one of the 16 patterns, press a key to test, and if the fan does not respond, move to the next pattern. Repeat until the fan responds.
- If the fan or light turns on and off by itself, another remote is interfering: set a new matching pattern on both the remote and the receiver.
Compatibility
Listed for the Hampton Bay 7058RLCK-03 Green receiver (304 MHz).
Dimensions: 4.00 x 4.00 x 3.00 (W x L x D, inches)